If you're ever having trouble hiding your Moto G's stylus from view, removing and replacing the stylus screen might be helpful. It's easy to do, but it can take a little effort. Here's how to do it.

How to Remove and Replace a Stylus Screen on a Moto G.

Stylus the screen near the top and bottom of the stylus. Lift on the screen and remove it from the moto g stylus screen replacement can be tricky, but don’t worry; we’ve got you covered! First, remove any adhesive on the old stylus screen using a utensil or water droplets. Next, unscrew the screws that hold the stylus screen to the phone. Once those are out of the way, gently peel off the protective film that covers the surface of your new stylus screen. There should be enough adhesive left to place your new stylus screen (if not, use some adhesive remover wipes to adhere it). Be sure to align both screens, so they’re facing inward when installing them (this will ensure that they line up properly when you turn on your Moto G). Install the screws back into place and screw everything down again. Finally, reattach any other attachments like microphones or speakers if necessary.

Replace the Stylus Screen.

Stylus one end of a new stylus screen and fit it over one end of an old one (the ends should still be touching each other). Screws should already be in place at this point. Gently twist so that both screens face inward towards each other, and install them into position by screwing them in from below using gentle pressure from both sides of the phone (you may need to do this in two steps). If you have trouble getting your old screens to show while installed on your new ones, try turning them around. Hence, they face away from each other first and then struggle with trying to get them installed correctly afterward - eventually, they'll show correctly when turned around! Install other attachments like microphones or speakers before turning off your Moto G.

How to Use a Stylus on a Moto G.

First, remove the battery cover to remove the stylus from your Moto G parts of a phone. Then unscrew the top of the Moto G and gently pull the stylus out of its connector. There are two tabs at the back of the stylus that need to be released to allow you to replace them.

Replace the Stylus

To replace the stylus, insert a new stylus into its connector and screw it back in place. Be sure to put pressure on both tabs to ensure a good connection between the stylus and the phone.

How to Use a Stylus on a Moto G.

First, remove the battery cover to remove the stylus from your moto g power screen replacement. Then, use a screwdriver to remove the stylus mount. With the stylus off, be sure to liberally clean the entire screen with alcohol or a product like Windex. Once the stylus mount and stylus have been removed, use a paperclip to remove the black connector from the end of the stylus. Be sure to preserve the connector, as it can be used in future repairs.

Replace the Stylus

To replace the stylus on your Moto G phone for parts, follow these steps: Remove the battery cover and place it aside. Insert new batteries into your Motorola Moto G (4th gen), and insert them into the phone as instructed by your manufacturer. Place the new stylus into its mount and reattach it to the phone using screws (if needed).

Conclusion

If you own a Moto G and need to remove or replace a stylus screen, follow these simple steps. First, remove the stylus screen by removing the battery cover. Next, replace the stylus screen by screwing the old stylus screen into place and screwing in the new one. If you own a Moto G and need to remove or replace a stylus screen, follow these simple steps. First, remove the stylus screen by removing the battery cover. Next, replace the stylus screen by screwing the old stylus screen into place and screwing in the new one.